Moen clickinstall bathroom faucet how to#
Moen clickinstall bathroom faucet install#
Moen clickinstall bathroom faucet driver#

Once inside the valve, retrieve the screwdriver/hex wrench and press on the seat with your your finger to properly install them.

Slide in the spring in the seat and use a screwdriver or hex wrench to stick them inside the valve.

The wide side is the one which goes inside the valve while the narrow side is connected to the seat.

If you look at the 2 springs, you will notice that there is a wide and a narrow end.

Note: You must replace the cam and ball assembly if the faucet was leaking from the base of the handle. You can however decide to replace the cam, packing and ball assembly as well. In most of the repairs I have performed, the springs and seats are usually the culprits in a leaking Delta bathroom faucet. You do not want to burr the valve in any way since that will scratch the ball as well and the faucet will start to leak again. You need to be very careful if you decide to scrape off the minerals.

Moen clickinstall bathroom faucet driver#

Just insert the screw driver and tilt it to the side to lift them off.Ĭheck if there are mineral deposits inside the valve body.

Use a hex wrench or screwdriver to remove the seat and springs.This makes it easy to remove and install the faucet parts. Use a towel to soak up the water inside the valve body.Lift off the Cam, packing and ball assembly.This is the dome-shaped piece which holds the assembly in place. Unscrew the cap using the wrench or channel locks.This is a thin ring which holds all the faucets parts in place.

Remove the Cam, Ball Assembly, Seat and Springs Remove the screw with a hex wrench and remove the handle.ģ. The screw may also be covered by a plastic piece.

If you have a lever-handle, it will be installed using a hex screw from underneath it.

Remove the screw using a Philips screwdriver and pull out the knob.

If you have a knob-handle, pry off the index cap at the front using a sharp knife or flathead screwdriver to reveal the screw.

Both of these handles are joined to the faucet stem using a screw. You do not want to drop anything down to the drain.ĭepending on the type of faucet you have, you will either have a knob-handle or lever-handle.

Open the faucet to drain the water already in the hoses.

Turn them clockwise to turn off water to the faucet. Those are your sink faucet’s shut off valves for both cold and hot water.

Duck underneath your bathroom sink and you will see 2 oval-shaped knobs.

Moen clickinstall bathroom faucet how to#

Once you have all the necessary items, this is how to proceed: 1. How to Fix a Leaking Single-Handle Delta Bathroom Faucet Image courtesy: Deltaįor this repair, you will need the following: Related: How to fix a leaking Delta bathroom faucet. If you have a double-handle Delta bathroom faucet, scroll down to the next section. Since Delta makes both single-handle and double-handle bathroom faucets, we will look at both, starting with the single-handle faucet. If the leak is from the base of the handle, you will need to replace the stem assembly (double-handle faucets) or cam, packing and ball assembly (single-handle faucets).Īlternatively, you can buy a complete repair kit and replace all the parts. To fix a leaking Delta bathroom faucet, you will need to replace the seats and springs if the leak is if from the spout. On the other hand if it is leaking from the base of the handle you have a bad stem assembly (double-handle faucet) or defective ball assembly (single-handle faucet).

If your Delta bathroom faucet is leaking from the faucet spout, the faucet seats and springs are worn out. It could also be caused by a defective stem assembly (double-handle faucet) or worn out cam, packing and ball assembly (single-handle faucet). If you live in area with hard water, your faucets are more likely to leak and/or corrode that faucets in areas with soft water.Ī leaking Delta bathroom faucet is usually caused by worn out faucets seats and springs which fail to make a watertight seal. Water quality also plays a big part in faucet parts’ longevity. Continued use of the faucets causes wear and tear resulting in leaks. Why is My Delta Bathroom Faucet Dripping?ĭelta faucets are without a doubt some of the best in the market, but that does not mean they will not leak from time to time.